Well... I did spend the day in the studio alright, but it was work, work, work in here too. Basically, I wanted to see if I could find a few more of my supplies before I went into making stuff mode. Then I decided I'd go ahead and unpack most of the boxes, to see what all I have to find new places for. That lead to another day of unpacking.
However, it was fun, because I did find more treasure.
I was happy to see that Lionesse survived her ocean crossing!
I dusted her off and let her stretch her legs for a minute or two.
Then, sadly, it was back into the box with her - that's still the safest place to be until I get a quake proof home for her. She's actually been living in that box since I won her; I've been too afraid to display her, in case something bad happens. But I do think she's pretty and I'd love to have her out where I can see her. (I say, now that I'm living in a highly active earthquake area...)
Another good find was the first sighting of some of my bodies.
I took them out and put them on a shelf - it's not too big a deal if they tip over. I also found most of my Stablemate bodies, my heat gun, and my trusty old Dremel. Except for primer, paint, and sealer (which sadly I was not allowed to bring...), I'm almost ready to start working on custom models again!
Tomorrow I may do some more unpacking in the studio. I unpacked everything today except the "figurines" (horses) and I think I might take a peek in those boxes tomorrow. Other than that, tomorrow...
I will make something!!! ;)
YAY! I also have a question. When you want to remove a mane on a horse completely is it best to use a dremel? If so, what attachment? I need to remove the mane on the Henry Fjord body and I've never done that before.
ReplyDeleteYep, I use a dremel for that. If the mane (or tail) is away from the body, you can use a cutoff wheel to cut away most of the plastic. Then to remove the rest and smooth it out, or to remove a short/attached mane or tail, I use one of the sanding drums or bands I think they are called. There are two different sizes and I usually just go with whatever works, like the smaller one on smaller models or to get into tight places and the big one on bigger models or to remove a lot of material.
DeleteDon't forget to wear eye protection! (sometimes I forget and get plastic bits in my eye - no good) Also it's good to do it in a well-ventilated area since the plastic can make fumes, especially when you're removing a lot of material. I think some people will wear some sort of mask, I haven't done it, but that's an option too. I hope that helps! :)
Thank you so much! I got the horse in the mail today so I'll be "roaching" a plastic mane now.
DeleteYou're very welcome! Have fun! :D
Delete